I don’t print any abrasive materials at all. Pretty much only normal PLA and PETG.
I noticed, that my print quality gradually went down quite a bit, especially in the last few prints. I had a lot of stringing, weird blobs, and scarred surfaces.
Now, the print quality is as good as it should be!
They are dirt cheap. You can get a set of 10-15 generic ones, in different sizes, for only a few bucks. Don’t forget that they are consumables.
This solution to abrasive filament is a tungsten nozzle or one of the ruby tip ones. The cost is a bit expensive but with a tungsten nozzle you might be one and done
Forget about tungsten, get yourself a Diamondback nozzle They’re pretty much indestructible regardless of the hardness of the filament! Ask our boy Zack over at Voidstar Labs