As a Bose engineer, thank you! Most folks don’t realize all Bose products are designed in Massachusetts.

Or master and slave boards…

Yes and because wiregurad is stateless you’ll need a script that checks if your DNS endpoint has updated and restart the wireguard interface so it pulls the fresh DNS/updated IP address. I had to make said bash script for my nodes.

Way too thin to add useful insulation. Much more likely for sound deadening to stop horrible echos.

I ran it for awhile but the upgrades even in docker because unnecessarily difficult and annoying. They often rolled out so many incremental and useless updates instead of one large one every once in awhile. I abandoned it for mattermost.

I bought all the gear to do 10gbe but ultimately went back to 1gig simply because the power consumption. The switch alone used 20w at idle and each NIC burned 8w and I couldn’t justify it.

So you have photoprism pointed to a folder but you push photos into the folder witb syncthing. How do you trigger the re-index or its somehow automatic? I run my photoprism in docker and I always had to manually trigger the index after changes to the folder.

As someone who has and still used photoprism for over two years and donated heavily…steer clear. Their update cycle is slow and the things they keep adding don’t seem helpful. Still no multi-user support. If you don’t upload new photos via photoprism using WebDAV you have to make your own scripts to watch for changes and refresh which took a lot of time for me to setup.

I’m just going to start using Nextcloud and Memories app going forward.

Most folks ignore laptops, but if you’re OK with USB storage or getting the special caddy to install the internal 2.5" drive you can get great deals on laptops. This one idles around 4W with the screen off.

Status symbol and to project a personality.

I was going to retort they’re similar sizes but the ioniq 5 is almost 20" longer, damn. My perception is so warped because everything is a god damn SUV and I get excited even when someone makes a large hatchback.

Ioniq 5?

I use the onboard CPU of my ryzen 5600g for my jellyfin and nextcloud (memories app) duties and it works flawless.

May or may not be an option for you but buy any camera that supports rtsp, only allow that traffic from their network through and block everything else. Works fine for me and my Amcrest cameras. You could accomplish this with a pi and a USB network card and some basic iptables.

deleted by creator

It’s heavier than air and will displace oxygen in the area causing asphyxiation.

I had to google ventoy and now I feel like a cave man because I have a dish with 6 flash drives that all have different ISOs

Been using it for over a year on two 8tb SSDs in strip and 14tb as mirror. This is on Debian and its flawless and wonderful. I run btrkbk hourly for snapshots, backups to remote locations and house keeping with 6 months of hourly snaps. Life is great.

I have the micro form factor I assume the same as you. Basically just a laptop in a small desktop case. I never installed tlp I’ll have to give that a shot but I’m pretty sure it’s optimized. I have two as servers and one as a router and I’d love to get it down to 12w total! I monitor the whole server rack with an iotawatt and all my servers and networking gear hovers around 75w idle.

I’d question that. I have three 3080 and they’re consistently about 8W each with one ssd and onboard graphics. I even went so far to splice three barrel jacks to a single 60w power supply that powers all three to avoid the losses of an additional 2 power supplies and this gets me the 8w idle power with Debian and throttling.