I tried to start my laptop earlier, only for nothing to happen. It won’t start on battery or when plugged in (it can run without a battery when plugged in). The battery does seem to be dead, and so is the 3V CMOS battery.

I opened it up and noticed a circle visable on one of the inductors. Hopefully you can see it in the picture.

Could this be the problem, or is that normal?

Update: I’ve tested some suggestion and watched some repair videos, but I found nothing. Goodbye old friend 🥲🤚

Thanks for the help guys

  • UnH1ng3d@lemmy.worldOPEnglish
    1·
    2 days ago

    Current passes through it unfortunately, maybe it’s possible there is a short between coils though. The inductor doesn’t get hot or anything when plugged in.

    • I think I’ve managed to check the battery voltage, and it seems completely dead (mV).
    • I can measure 20v on the PCB whe n plugged in.
    • No fan, no LEDs, etc with either power source. There might be the slightest electrical squeek from somewhere, I will try and find out what …

    Even if I don’t manage to fix it. Thanks for the suggestions 👍

    • greyfox@lemmy.worldEnglish
      2·
      2 days ago

      When you saw that 20v on the board I assume that was right next to the charge port? There are often fuses that should be very close to that connector that you can check for continuity on. Usually marked with zeros because they act like a zero ohm resistor.

      Even if the fuse is blown that might just be a sign that something further down the line failed but it would be an easy thing to check at least.

      • UnH1ng3d@lemmy.worldOPEnglish
        1·
        13 hours ago

        I found the fuse, but it wasn’t blown 🥲 I’ve looked over the board, and watched some repair videos but I haven’t found anything. I’ve called it dead now.